Table of Contents
Advertisement
The following illustration shows the memory slots on the system board.
DIMM 4 (DDR4)
DIMM 3 (DDR3)
DIMM 2 (DDR2)
DIMM 1 (DDR1)
DIMM 8 (DDR8)
DIMM 7 (DDR7)
DIMM 6 (DDR6)
DIMM 5 (DDR5)
To install a DIMM, complete the following steps:
1. Read the safety information that begins on page v, and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the server cover (see "Removing the cover and bezel" on page 10).
4. Open the retaining clip on each end of the DIMM connector.
5. Touch the static-protective package containing the DIMM to any unpainted metal
6. Turn the DIMM so that the DIMM keys align correctly with the slot.
7. Insert the DIMM into the connector by aligning the edges of the DIMM with the
22
eServer 326m Type 7969: Installation Guide
on page 9.
all external cables.
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
surface on the server. Then, remove the DIMM from the package.
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
Advertisement
Table of Contents
