IBM 326m - eServer - 7969 Installation Manual page 28

v The optional IBM Remote Supervisor Adapter II can be installed only in PCI-X
14
eServer 326m Type 7969: Installation Guide
slot 1. Use the 20-pin planar cable with USB signals that comes with the Remote
Supervisor Adapter II to connect the 20-pin connector on the rear edge of the
adapter to the Remote Supervisor Adapter II connector (JMGT1) on the system
board. For details about installing a Remote Supervisor Adapter II, see the
documentation that comes with the adapter. The following illustration shows the
cable routing.
Remote Supervisor
Adapter II
Remote Supervisor
Adapter II connector
(JMGT1)
20-pin planar cable
with USB signals