Table of Contents
Advertisement
Slide Rail Kit
WARNING
Avoid injury: To avoid personal injury when unpacking the server, use
only a mechanical assist unit to lift it off the shipping pallet. The
minimum server configuration weighs 26 kg (57 lbs); the maximum
weighs 40 kg (88 lbs).
Do not attempt to lift or move the server by the handles on the power
supplies.
Use only a hand-truck or other mechanical assist unit to move the server
from one location to another.
To mount the SRKA4 MP server system in a slide rail configuration, install the slide rail kit as
directed in this section. The slide rail kit contains slide rail assemblies, EIA brackets, and several
screws, nuts, and bolts.
The slide rail kit contains two slide rail assemblies. As shown in Figure 3, the slide rail assembly
contains three moving parts: the inner member, the intermediate member, and the outer member.
The slide rail kit contains four EIA brackets. Two brackets are labeled FL/RR. One is connected
to the front left (FL) of the slide assembly; the other is connected to the rear right (RR). The
remaining two brackets are labeled FR/RL. One is connected to the front right (FR) of the slide
assembly; the other is connected to the rear left (RL). Figure 3 shows where the brackets are
attached to the slide rail assembly.
Screws, lock nuts, and washers are provided for the assembly of each slide rail and attaching the
slide rail to the server. However, you must supply the screws that secure the slide rail to the rack.
A.
Inner member
B.
Intermediate member
C. Outer member
D. Front left bracket
E.
Rear left bracket
A
B
D
Figure 3. Slide Assembly Fully Extended
The inner member is the narrowest piece of the slide assembly.
The intermediate member is the middle member of the slide assembly.
The outer member is the widest piece of the slide assembly.
The location of the front left bracket labeled FL/RR.
The location of the rear left bracket labeled FR/RL.
C
E
OM09982
SRKA4 /ISP4400 Server System 11
Advertisement
Table of Contents
