Canadian Programming/Gate Programming - Dodge 2007 Durango Owner's Manual

164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
6. Firmly press and release the learn or smart button.
(The name and color of the button may vary by manu-
facturer.)
NOTE: There are 30 seconds in which to initiate step
eight.
7. Return to the vehicle and firmly press, hold for two
seconds and release the programmed HomeLink button.
Repeat the press/hold/release sequence a second time,
and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this
sequence a third time to complete the programming.
HomeLink should now activate your rolling code
equipped device.
NOTE: To program the remaining two HomeLink but-
tons, begin with Programming step two. Do not repeat
step one. For questions or comments, please contact
HomeLink at www.homelink.com or 1-800-355-3515.

Canadian Programming/Gate Programming

Canadian radio-frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of
transmission which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to time-out in the same manner.
If you live in Canada or you are having difficulties
programming a gate operator by using the Program-
ming procedures (regardless of where you live), replace
Programming HomeLink step 3 with the following:
3. Continue to press and hold the HomeLink button
while you press and release every two seconds ( cycle )
your hand-held transmitter until the frequency signal has
successfully been accepted by HomeLink. (The EVIC will
display "CHANNEL X TRAINING" and then "CHAN-
NEL X TRAINED".) Proceed with Programming step
four to complete.