Dodge 2007 Durango Owner's Manual page 163

3. Simultaneously press and hold both the HomeLink
button that you want to train and the hand-held trans-
mitter button. Do not release the buttons until step 4 has
been completed. The EVIC will display "CHANNEL X
TRAINING", once the transmitter is programmed the
EVIC will display "CHANNEL X TRAINED". X refers to
the desired channel being trained (1,2 or 3).
NOTE: Some gate operators and garage door openers
may require you to replace this Programming Step 3 with
procedures noted in the Gate Operator/Canadian Pro-
gramming section.
4. Once "CHANNEL X TRAINED" is displayed on the
EVIC, release both buttons. Programming is now com-
plete. When the HomeLink button is subsequently
pressed, "CHANNEL X TRANSMIT" is displayed on the
screen and your device should be activated, (garage door
should open).
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 163
NOTE: To program the remaining two HomeLink but-
tons, begin with Programming step two. Do not repeat
step one.
NOTE: If the EVIC display shows "CHANNEL X TR-
ASMIT" (where X is channel 1,2 or 3) but your device
does not activate, the device may be equipped with a
"rolling code" system. Continue with the following steps
five through seven to complete the programming of a
rolling code equipped device (most commonly a garage
door opener manufactured after 1995). The assistance of
a second person may make the following programming
steps quicker and easier.
5. Programming a Rolling Code System
At the garage door opener receiver (motor-head unit) in
the garage, locate the learn or smart button. This can
usually be found where the hanging antenna wire is
attached to the motor-head unit.
3