Cisco WS-CBS3032-DEL Software Configuration Manual page 1134

Chapter 44 Configuring Cache Services By Using WCCP
Configuring WCCP
This example shows how to configure SVIs and how to enable the cache service with a multicast group
list. VLAN 299 is created and configured with an IP address of 175.20.20.10. Gigabit Ethernet port 1 is
connected through the Internet to the server and is configured as an access port in VLAN 299. VLAN
300 is created and configured with an IP address of 172.20.10.30. Gigabit Ethernet port 2 is connected
to the application engine and is configured as an access port in VLAN 300. VLAN 301 is created and
configured with an IP address of 175.20.30.50. Fast Ethernet ports 3 to 6, which are connected to the
clients, are configured as access ports in VLAN 301. The switch redirects packets received from the
client interfaces to the application engine.
Note Beginning with Cisco IOS Release 12.2(58)SE, both permit and deny ACL entries are supported in
WCCP redirect lists.
Switch# configure terminal
Switch(config)# ip wccp web-cache 80 group-list 15
Switch(config)# access-list 15 permit host 171.69.198.102
Switch(config)# access-list 15 permit host 171.69.198.104
Switch(config)# access-list 15 permit host 171.69.198.106
Switch(config)# vlan 299
Switch(config-vlan)# exit
Switch(config)# interface vlan 299
Switch(config-if)# ip address 175.20.20.10 255.255.255.0
Switch(config-if)# exit
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 299
Switch(config)# vlan 300
Switch(config-vlan)# exit
Switch(config)# interface vlan 300
Switch(config-if)# ip address 171.69.198.100 255.255.255.0
Switch(config-if)# exit
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 300
Switch(config-if)# exit
Switch(config)# vlan 301
Switch(config-vlan)# exit
Switch(config)# interface vlan 301
Switch(config-if)# ip address 175.20.30.20 255.255.255.0
Switch(config-if)# ip wccp web-cache redirect in
Switch(config-if)# exit
Switch(config)# interface range gigabitethernet1/0/3 - 6
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 301
Switch(config-if-range)# exit
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
44-10
OL-13270-06