Cisco WS-CBS3032-DEL Software Configuration Manual page 1020

Configuring ISO CLNS Routing
Command
Step 7
isis retransmit-interval seconds
Step 8 isis retransmit-throttle-interval
milliseconds
Step 9 isis priority value [level-1 | level-2]
Step 10 isis circuit-type {level-1 | level-1-2 |
level-2-only}
Step 11 isis password password [level-1 |
level-2]
Step 12 end
Step 13 show clns interface interface-id
Step 14
copy running-config startup-config
To return to the default settings, use the no forms of the commands.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
39-78
Purpose
(Optional) Configure the number of seconds between retransmission of
IS-IS LSPs for point-to-point links. The value you specify should be an
integer greater than the expected round-trip delay between any two routers
on the network. The range is from 0 to 65535. The default is 5 seconds.
(Optional) Configure the IS-IS LSP retransmission throttle interval, which
is the maximum rate (number of milliseconds between packets) at which
IS-IS LSPs will be re-sent on point-to-point links. The range is from 0 to
65535. The default is determined by the isis lsp-interval command.
(Optional) Configure the priority to use for designated router election. The
range is from 0 to 127. The default is 64.
(Optional) Configure the type of adjacency desired for neighbors on the
specified interface (specify the interface circuit type).
level-1—a Level 1 adjacency is established if there is at least one area
•
address common to both this node and its neighbors.
level-1-2—a Level 1 and 2 adjacency is established if the neighbor is
•
also configured as both Level 1 and Level 2 and there is at least one
area in common. If there is no area in common, a Level 2 adjacency is
established. This is the default.
level 2—a Level 2 adjacency is established. If the neighbor router is a
•
Level 1 router, no adjacency is established.
(Optional) Configure the authentication password for an interface. By
default, authentication is disabled. Specifying Level 1 or Level 2 enables
the password only for Level 1 or Level 2 routing, respectively. If you do not
specify a level, the default is Level 1 and Level 2.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 39 Configuring IP Unicast Routing
OL-13270-06