Table of Contents
Advertisement
'hrn Signal and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These po.sitions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all
the way up or
down. When the turn is finished, the lever will
return automatically.
An arrow on the instrument
panel will flash in the
direction of the turn or
lane change.
To signal a lane change, just raise or lower the lever
until.the arrow starts
to
flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release
it.
. ,
If you move the lever all the way up or down, and the
arrow flashes at twice the normal rate, a signal bulb
may be burned out and other drivers may\n.ot see your
turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check for burned-out bulbs and a blown
fuse (see "Fuses and Circuit Breakers" in the Index).
Headlamp HighLow Beam Changer
To change the headlamps from low beam
to
high or high
to low, pull the multifunction lever all the way toward
you. Then release it.
When
the
high beams
are
on,
this light on the
instrument panel also
will be on.
Advertisement
Table of Contents
