DOD Bass30 Owner's Manual page 17

1. Comp/Wah - This button will access the Compressor/Limiter and Wah effects. Successive presses of this
button will toggle between the Compressor/Limiter and the Wah. The selected effect is indicated by the flashing
LED. The status of the selected effect can then be changed by rotating the Data Wheel. The Compressor contains 4
parameters available for adjustment. These parameters will light when the Compressor has been selected and may
be accessed by using the Parameters button. Compression and Wah can be used simultaneously. See page 18 for a
complete description of Compression and Wah effects.
2. Expression - This button is used to assign functions to the Expression Pedal. Pressing this button once
will cause the Expression LED and the LED of the Parameter currently assigned to the Expression pedal to begin
flashing. Rotating the Data Wheel will change the Expression Pedal's Parameter assignment. The new Parameter
selection will be indicated by a flashing LED in one of the effects groups, or parameter section. Only one
Parameter at a time can be controlled by the Expression Pedal. Successive presses of this button will allow you to
edit the range of the Expression Pedal. See page 15 for more information on assigning the Expression Pedal.
3. Model - This button will access the Amp and Guitar Modeling section. The LED next to the currently
selected Amp/Guitar Model will flash. Successive presses of the Model button will advance through all available
Amp and Guitar Models. Only one Model can be used in each Preset. The Display will show the status of the
Modeling section as either on, or two dashes -- indicating bypass. Rotate the Data Wheel to change the
status. See page 18 for a complete description of Amp/Guitar Models.
4. Tone/Gate - This button will access the Gain, and EQ of the selected Model, as well as Volume and Noise
Gate. The selected Modeling Parameter will be indicated by a flashing LED. The Display will show the value of the
selected Parameter. Rotating the Data Wheel will adjust the value. Successive presses of the Tone/Gate button will
advance through these Parameters. A separate value for each Modeling Parameter can be stored to Presets. See
the Modeling section on page 18 for a complete description of Tone adjustments and page 20 for the Noise Gate.
13