Belkin F7D1102 User Manual page 33

InfOrMaTIOn
IMPOrTanT nOTe:
radiation exposure statement
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. To
maintain compliance with FCC RF exposure compliance requirements,
please follow operation instructions as documented in this manual.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
SAR compliance has been established in typical laptop computer(s)
with USB slots, and this product could be used in typical laptop
computers with USB slots. Other applications, such as handheld
PCs or similar devices, have not been verified and may not comply
with related RF exposure rules and such use shall be prohibited.
The availability of some specific channels and/or operational
frequency bands is country-dependent and firmware is
programmed at the factory to match the intended destination.
The firmware setting is not accessible by the end user.
Modifications
The FCC requires the user to be notified that any
changes or modifications to this device that are not
expressly approved by Belkin International, Inc., may
void the user's authority to operate the equipment.
Industry Canada statement
This device complies with RSS-210 of the Industry Canada
Rules. Operation is subject to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference
that may cause undesired operation of the device.
IMPOrTanT nOTe:
IC radiation exposure statement
This equipment complies with IC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. To
maintain compliance with IC RF exposure compliance requirements,
please follow operation instructions as documented in this manual.
europe – eU declaration of Conformity
This device complies with the essential requirements of the
(R&TTE) Radio and Telecommunications Terminal Equipment
Directive 1999/5/EC, (EMC) Electromagnetic compatibility Directive
2004/108/EC, and the (LVD) Low Voltage Directive 2006/95/
EC. A copy of the European union CE marking "Declaration of
Conformity" may be obtained at the website: www.belkin.com/doc.
31