Application Rules - D-Link DIR-655 - Xtreme N Gigabit Router Wireless User Manual

Section 3 - Configuration
Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and others. These applications
have difficulties working through NAT (Network Address Translation). Special Applications makes some of these applications work with the DIR-655.
If you need to run applications that require multiple connections, specify the port normally associated with an application in the "Trigger Port" field,
select the protocol type as TCP or UDP, then enter the firewall (public) ports associated with the trigger port to open them for inbound traffic.
The DIR-655 provides some predefined applications in the table on the bottom of the web page. Select the application you want to use and enable
it.
Name: Enter a name for the rule. You may select a pre-defined
application from the drop-down menu and click <<.
Trigger: This is the port used to trigger the application. It can be either
a single port or a range of ports.
Traffic Type: Select the protocol of the trigger port (TCP, UDP, or Both).
Firewall: This is the port number on the Internet side that will be used
to access the application. You may define a single port or a
range of ports. You can use a comma to add multiple ports
or port ranges.
Traffic Type: Select the protocol of the firewall port (TCP, UDP, or Both).
Schedule: The schedule of time when the Application Rule will be
enabled. The schedule may be set to Always, which will allow
the particular service to always be enabled. You can create
your own times in the Tools > Schedules section.
D-Link DIR-655 User Manual

Application Rules

28