Testing Of Safety Interlock Systems - Dixon ZTR 52 - 27 KOH, 60 - 27 KOH, 60 - 30 KOH, 72 - 27 KOH Operator's Manual

OPERATION INSTRUCTIONS

TESTING OF SAFETY INTERLOCK SYSTEMS

WARNING
!
The following tests should be performed at the start of each
mowing day.
BLADE DRIVE SWITCH TEST
1. Put park brake in ON position.
2. Swing control levers to outward position.
3. Engage blade drive.
4. Turn ignition switch to START.
Engine should not turn over or attempt to start.
SEAT SWITCH TEST
1. In a SAFE AREA away from bystanders, start the engine.
2. Leave control levers in outward position and put park brake ON
position.
3. Engage blade drive.
4. Raise slightly off seat. Engine should stop!
NOTE: If any safety check fails, do not operate the mower until
the system has been checked and repaired by an
authorized Dixon dealer.
Failure to observe the following instructions
could result in serious injury or death.
31