CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE:
DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:
SPECIFICATIONS
Model ZTR 5424
11 GA - rectangular tube
Two piece - made of rotational molded polyethylene. Front body contains
access panels for battery service and engine to mower deck belt removal. Rear
body tilts up to allow service on the entire drive system.
Designed for operator comfort by use of high density closed cell foam padded
back and arm rests, upholstered with Cordura™ water-repellent fabric. Seat is
adjustable fore and aft.
1 3 GA stamped steel construction 3 blades combine for a 42"
cut width Cut height approximately 1 .5" to 4.5" via 7 position
lift handle
Electric clutch
Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
17HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, dual
element air cleaner, impulse fuel pump
Electric by key switch operation with safety interlocks on parking brake and
blade drive clutch.
Front
11 X 4 X 5 smooth profile
Rear
18 X 9.5 X 8 Multi Trac CS
Front
16-21 Ibs. Rear
,
\
'
Fuel - 4.8 gallons total (dual tanks) Hydrostat oil tank - 3 quart with
in-line 10 micron filter Hydrostat oil recommendation, refer to page
37 Engine - 2 qts. SAE 30 (with filter)
Width
54"
Height
45"
Length
72"
Weight
61 5 Ibs.
Additional information provided in service instructions underthe individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
8- 14 Ibs.
Page 9