Ignition Switch; Throttle Control Lever; Circuit Breaker - Dixon Operator's Manual electric lawn mower Grizzly 2005 Safety And Operating Manual

MOWER BLADE SWITCH:
To engage blades: pull up on switch
To disengage blades: push down

IGNITION SWITCH:

•
Turn to start position to crank engine.
Release when it starts.
•
For headlights - rotate switch one notch
counter-clockwise from run.
Note: Remove key when mower is not in use.
CHOKE CONTROL LEVER:
•
Located on the control panel to the operator's right.

THROTTLE CONTROL LEVER:

•
Located on control panel to operator's right.
•
Controls engine speed.
•
While mowing, throttle control should be set to MAXIMUM
or wide open setting to insure adequate cooling of the
engine and to maintain mower deck blade speed.

CIRCUIT BREAKER:

•
If circuit breaker pops up, it disconnects the power. Wait 2
minutes and push to reset.
•
If it pops up again, there is a short circuit. Stop and find
fault or contact your dealer.
CONTROLS
20