Install Windows Nt 4.0 Display Driver; Installation Procedures - Asus AGP-V6600 MX User Manual

4. Software Reference

Install Windows NT 4.0 Display Driver

WARNING!
Before installing the display driver in Windows NT 4.0, make sure that
you have installed Windows NT 4.0 Service Pack3 or later, to take full advan-
tage of the ASUS AGP-V6800 AGP features. (You may download service packs
at http://www.microsoft.com/ntworkstation/downloads.)
NOTE: The following steps assume your CD-ROM drive letter is D.

Installation Procedures

1. Start Windows NT, switch display properties to VGA mode (16 colors, 640 x 480
pixels), then restart your computer to make the change.
2. After your computer restarts, right-click the desktop and click Properties.
3. Click the Settings tab.
4. Select Change Display Type.
5. Select Adapter Type and click Change.
6. Click Have Disk.
7. Insert the CD installation disc.
8. Type D:\NT40 or click Browse to select the path of the display driver for Win-
dows NT. Click OK.
9. Select ASUS V6800 and then click OK.
10. Windows NT will once again prompt for confirmation. All appropriate files are
then copied to the hard disk. When all files are copied, go back to the Display
Properties box by clicking Close. Click Apply.
11. The System Settings Change dialog box is displayed. Click Yes to restart Windows.
12. Windows NT will restart with the default settings. The Display applet will ap-
pear to allow for mode selection.
72 ASUS V6600/V6800 Series User's Manual