DURKOPP ADLER 911 Operating & Installation Instructions Manual page 43

Set return path after thread breakage
(min. = 0 .. max. 20; def. 5 stitches)
Number of stitches of the reverse drive effectuated after
detection of thread breakage.
Position of bobbin change X
(min. = -300... max. = 300; def. = 230 mm)
Position of bobbin change Y
(min. = -300... max. = 300; def. = +90 mm)
MP4 - Thread cutting
Cutting speed
(min. = 70 .. max. 500; def. 180 U/min)
Speed of the trimming stitch.
Cutting position on
(min. = 0 .. max. 359; def. 180 degrees)
Angular position of the needle at which the thread trimming
knife is switched on.
Cutting position off
(min. = 0 .. max. 359; def. 359 degrees)
Angular position of the needle at which the thread trimming
knife is switched off.
Set thread tension during thread cutting
(min. = 00 .. max. 100; def. 10%)
Thread tension of the trimming stitch.
Position for thread tension during thread cutting
(min. = 0 .. max. 400; def. 370 degrees)
Starting angle for the thread tension at trimming (with an angle
of more than 359 degrees the thread tension is only activated
with the next stitch.
MP5 - Clamping thread
Closing the thread clamp, first stitch
(min. = 0 .. max. 250; def. 180 degrees)
Starting angle for the closing of the tread clamp during
the first stitch.
Open the thread clamp, first stitch.
(min. = 0 .. max. 359; def. 340 degrees)
Starting angle for the opening of the tread clamp during
the first stitch.
If the angles for closing and opening are identical the thread
clamp will not be activated.
1
39