Installing The Proliant 8500 I/O Module Upgrade Kit Support Software Cd - Compaq ProLiant 8500 Upgrade Manual

The first time the server is configured, the SmartStart program automatically
creates a system partition and installs the Compaq System Configuration
Utility and other Compaq utilities in that partition.
Refer to the Server Setup and Management pack for instructions on using
SmartStart.
Installing the ProLiant 8500 I/O Module
Upgrade Kit Support Software CD
The ProLiant 8500 I/O Module Upgrade Kit Support Software CD contains
the Compaq Support Paqs for Microsoft Windows NT Server 4.0 and
Microsoft Windows 2000. The CD also contains the Compaq System Erase
utilities. To begin the update:
1. Load the CD into the CD-ROM drive.
2. If Autorun is active, the Compaq Remote Deployment Utility screen is
opened. If Autorun is not enabled, run SETUP.EXE from the \NTCSP
folder.
3. Enter the Target Computer and then click on the Open Support Paq
button.
4. The Select a Support Paq to Open window displays with two files. If
you are running Windows 2000, highlight the BP000031 file. If you are
running Windows NT Server 4.0, highlight the BP000029 file.
5. Click the Open button.
The Compaq Remote Deployment Utility screen will display again with
all the components on the CD. By default, all components will be
flagged to be updated.
6. Click the Install button at the top of the screen to begin the installation
process.
After all components have been installed, a listing of the installed
components will display.
7. Continue with the "Updating the System Partition with Compaq Server
Diagnostics" section of this guide.
Compaq ProLiant 8500 Server I/O Module Upgrade Guide 5