U-Channel Access Panel - Compaq ProLiant 3000 Maintenance And Service Manual

U-Channel Access Panel

The U-channel access panel is removed for replacement only. To remove the U-channel
access panel:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Pull the drive cage assembly forward until it clears the front edge of the U-channel access
panel. See "Drive Cage Assembly" later in this chapter.
3. Remove the caster mounting support. See "Caster Mounting Support" earlier in
this chapter.
4. Remove the two T-15 screws securing the U-channel access panel to the chassis.
5. Slide the U-channel access panel forward, then pull it away from the chassis.
Figure 2-7. Removing the U-channel access panel
Reverse steps 1 through 5 to replace the U-channel access panel.
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
2-11