Waterproof Treatment For The Cable Joint Sections - Panasonic WV-CW504SE Installation Manual

Waterproof treatment for the cable joint sections

Adequate waterproof treatment is required for the cables when the camera with exposed cables is
installed by means of the camera mount bracket or it is installed under the eaves. The camera body
is waterproof, but the cable ends are not waterproof.
Be sure to use the supplied butyl tape at the connection parts of the power cord and video output
cable to apply waterproof treatment in the following procedure. Failure to observe this may cause
water leakage resulting in malfunction.
When using power
cord
When using video output cable
<How to wind the supplied butyl tape>
Stretch the tape by approx. twice (see the illustration below) and wind it around the cable. Insuffi-
cient tape stretch causes insufficient waterproofing.
Note:
• To install this product outdoors, be sure to waterproof the cables. The camera body is water-
proof (IEC IP66 or equivalent) only when installation specified in this document and appropriate
waterproofing are properly performed. The bracket is not waterproof.
• The cable shall be wound with butyl tape in a half-overlapping manner.
Stretch the tape to about twice.
Dobled length
27