Product Use; Operating In 2D Mode; User Controls And Osd Menu - Planar SD1710 Product User Manual

Product Use

Operating in 2D mode

Your SD 1710 unit can operate
either as a 3D stereoscopic
monitor or in the standard 2D
mode. There are two options to
convert to the 2D mode.
• Simply turn off the power to
one monitor.
• Lift the mirror and slide it
into the locked, upright
position. (See Figure 9.)
To return to 3D stereo, simply
reverse the procedure.
User controls and the OSD menu
The two monitors have a soft DC power switch in the center of the bottom
bezel. (See Figure 10.) This control is used for turning the monitor on or off.
To the right of the power switch is an LED power indicator. When the LED is
green, the power is on. A yellow
light indicates that the monitor is
in power-saving mode. When the
LED power indicator is off, the
monitor power is off. The left and
right Function buttons can be used
to control the Onscreen Display
menu selection. The left and right
Adjust buttons can be used to
decrease or increase the OSD setting.
The two monitors have an OSD menu that allows control of the Brightness
setting. Adjustment of the brightness is not a direct increase or decrease to
the overall luminance, but a driving voltage adjustment of the LCD panel. In
other words, setting the brightness to 0 (zero) does not reduce the luminance
2
to 0 cd/m . Note that changing the Brightness setting reduces the number of
discernable gray levels.
Figure 9. The StereoMirror monitor in 2D mode.
Figure 10. Controls and LED indicator.
7