Dish Network 104333 User Manual

Dish Network 104333 User Manual

Dish networks blue button remote control user's guides

Advertisement

T
ABLE OF
About the Remote Control............................... page 2
Remote Control Signals: UHF or IR.................page 2
Remote Control Modes ....................................page 3
Using the Remote Control Buttons ................ page 4
SAT (Satellite Receiver) Mode.........................page 4
TV (Television) Mode .......................................page 8
Remote Control Procedures............................ page 15
Controlling a Device.........................................page 15
Installing an Attenuator ....................................page 17
Controlling Sound Volume................................page 18
Receiver Volume Control...................... page 18
TV or Amplifier Volume Control............ page 19
Doing the Device Code Scan...........................page 20
Finding the Device Codes................................page 21
Device Codes ................................................... page 22
TVs...................................................................page 22
VCRs................................................................page 23
DVD Players ...................................................... page 25
Tuners and Amplifiers ......................................page 25
Cable TV Boxes ...............................................page 25
Trouble-Shooting Table ................................... page 26
Limited Warranty .............................................. page 28
If You Need Help ............................................... page 30
104333
C
ONTENTS
1

Advertisement

Table of Contents
loading

Summary of Contents for Dish Network 104333

  • Page 1: Table Of Contents

    Device Codes ... page 22 TVs...page 22 VCRs...page 23 DVD Players ... page 25 Tuners and Amplifiers ...page 25 Cable TV Boxes ...page 25 Trouble-Shooting Table ... page 26 Limited Warranty ... page 28 If You Need Help ... page 30 104333...
  • Page 2: About The Remote Control

    Remote Control Signals: UHF or IR BOUT THE The remote control gives you easy access to all the features of a DISH Network satellite TV system. You can set up the remote to control up to three devices other than the satellite TV receiver.
  • Page 3: Installing Batteries In The Remote Control

    The following sections describe how to use the remote control buttons. Each section describes only the buttons that work in one remote control mode, for example SAT mode or TV mode. 104333 ODES...
  • Page 4: Using The Remote Control Buttons

    (routed into the receiver’s Satellite In input) and another video signal such as cable or broadcast TV antenna input (routed into the receiver’s TV Antenna Cable In input). Press this button to open the Main Menu. ONTROL ECEIVER UTTON UTTON IDEO UTTON UTTON UTTONS 104333...
  • Page 5 Press this button to open the Program Guide. When the Program Guide is open, press this button to switch among Favorite Lists. ELECT Press this button to select a highlighted option or program in a menu. 104333 SAT (Satellite Receiver) Mode UTTON P AND...
  • Page 6 • When watching a program, press the Left button to open the Themes menu. ECALL Press this button to return to the last channel you were watching. Press it again to switch between the last two channels that you watched. RROW UTTONS UTTON IGHT 104333...
  • Page 7 ANCEL Press this button to cancel a procedure and to return to the previous menu or to watching a program. YSTEM Press this button to display the Important System Information menu. 104333 SAT (Satellite Receiver) Mode UTTON UTTON NFORMATION UTTON...
  • Page 8: Tv (Television) Mode

    Some of the features described below may not apply to the TV. See your TV owner’s manual for details about the TV’s features. If a remote control button is not described in this section, it does not work in TV mode. UMBER UTTONS UTTON 104333...
  • Page 9 Press the left-hand, minus (-) side of this button to lower the sound volume. Press the right-hand, plus (+) side of this button to raise the sound volume. ELECT The Select button works as the Enter button for a TV. 104333 UTTON IDEO UTTON UTTON...
  • Page 10: Vcr (Videocassette Recorder) Mode

    The VCR mode button’s back light turns ON to show that the remote is set to VCR mode. Make sure to keep the remote in VCR mode to use the buttons as described in this section. RROW UTTON UMBER UTTONS ECORDER UTTON UTTONS 104333...
  • Page 11 • The Left arrow button works as the Rewind button. Press this button to rewind a videotape. • The Right arrow button works as the Fast Forward button. Press this button to forward a videotape. 104333 VCR (VideoCassette Recorder) Mode UTTON OLUME...
  • Page 12: Aux (Auxiliary) Mode For Cable Tv Box

    Press the left-hand, minus (-) side of this button to lower the sound volume. Press the right-hand, plus (+) side of this button to raise the sound volume. UMBER UTTONS ODE FOR UTTON UTTON OLUME UTTON TV B ABLE 104333...
  • Page 13: Aux (Auxiliary) Mode For Tuner Or Amplifier

    See the device owner’s manual for details about the device’s features. If a remote control button is not described in this section, it does not work for a tuner or amplifier. 104333 UTTON RROW UTTON UMBER...
  • Page 14 This button works as the Input Select button for a tuner or amplifier. Use these buttons to change channels on the tuner or amplifier. Use this button to set up the remote control in AUX mode. UTTON UTTON OLUME UTTON UTTON RROW UTTON UTTONS 104333...
  • Page 15: Remote Control Procedures

    7. Turn the device back ON and try some other buttons to make sure they work. Sometimes, the Power button may work when other buttons do not. If the code works for other buttons, stop here. 104333 ROCEDURES EVICE Controlling a Device...
  • Page 16: Changing The Remote Control Address

    SAT button. 3. Use the number buttons to enter a number from 1 to 15. The SAT mode button backlight will blink off after you enter each digit, and then come on again. EMOTE ONTROL DDRESS 104333...
  • Page 17: Installing An Attenuator

    1. Remove the UHF antenna from the UHF Remote Antenna connection on the receiver back panel. 2. Attach a 10 dB attenuator to the UHF Remote Antenna connection. 3. Attach the UHF antenna to the attenuator. 104333 TTENUATOR Installing an Attenuator...
  • Page 18: Controlling Sound Volume

    7. If you are setting up the remote control for the first time, see Controlling a Device on pag e15. In step 4 of that procedure, use code 222 in TV mode to set up the remote to control the receiver, including the receiver sound volume. OUND OLUME ONTROL 104333...
  • Page 19: Tv Or Amplifier Volume Control

    2. Press the Pound (#) button. 3. Press the plus (+) side of the Volume button. 4. Press the 0 number button. 5. Press the Pound (#) button. The AUX mode button backlight blinks three times. 104333 Controlling Sound Volume OLUME ONTROL...
  • Page 20: Doing The Device Code Scan

    If the code is valid, the matching mode light blinks three times. 6. Press the Power button to turn the device back ON. 7. Try some other remote control buttons to make sure that you have the right code. For example 104333...
  • Page 21: Finding The Device Codes

    A quick flash is for zero. For example, the mode light flashes five times, pauses, flashes seven times, pauses, and flashes quickly for the 570 code. 104333 Finding the Device Codes EVICE ODES For example...
  • Page 22: Device Codes

    617, 625, 701 Magnasonic Magnavox 506, 520, 525, 536, 564, 565, 566, 567, 568, 569, 573, 575, 610, 710, 712 Marantz 506, 566, 573, 588, 712 Matsui 532, 609 Megatron Memorex 518, 532, 590, 695, 720 504, 505, 506, 571, 573, 104333...
  • Page 23: Vcrs

    589, 590, 594, 595, 596, 598, 599, 601, 602, 603, 604, 617, 695, 703 Seimitsu Sharp 526, 585, 591, 605, 606, 607, 608, 628, 629 Siemens 104333 Signature Silver Solavox Sony 500, 514, 521, 578, 609, 619, 622, 685, 686, 687, 688, 690...
  • Page 24 Totevision 580, 591 Unitech Vector Research 530, 600 Victor 561, 562, 600 Video Concepts 568, 600 Videosonic Yamaha 530, 592, 594, 600, 601 Zenith 500, 501, 533 Note: The following part of this table is for DVD players only. 104333...
  • Page 25: Dvd Players

    Scott 2659 Sherwood 2670 Sony 2667, 2668, 2672, 2673, 2674, 2680, 2684 Symphonic 2666 Technics 2652 Victor 2657 Yamaha 2663, 2682 104333 TV B ABLE OXES Eastern 2649 GI/Tocom 2640 Jerrold 2635, 2636 Memorex 2637 2646 Panasonic 2637, 2644, 2645...
  • Page 26: Trouble-Shooting Table

    Do the following: (a) write down the TV code, (b) reset the TV mode using code 222, (c) set up the AUX mode, and (d) reset the TV mode using the code that you wrote down in step (a). 104333...
  • Page 27 IR sensor on the receiver front panel. 104333 Remember that the remote control uses IR signals to control devices other than the receiver. IR signals travel only 40 feet or less, and cannot go through walls or other solid objects.
  • Page 28: Limited Warranty

    IMITED ARRANTY This warranty extends only to the original user of the DISH Network Remote Control (“you,” “your”) and is limited to the purchase price of the remote control. EchoStar Communications Corporation and its affiliated companies (“we,” “our,” “us”) warrant this remote control against defects in materials or workmanship as follows.
  • Page 29 If you return the defective equipment after the ten days, you will receive a full refund less an administrative fee. If damage to the defective equipment is found which DISH Network Service in its sole discretion determines is not covered by the warranty, we will charge your credit card our standard flat rate exchange fee.
  • Page 30: If You Need Help

    1. Review this Guide. 2. See the Trouble-Shooting Table on pag e26. 3. Call the DISH Network (3474). Have the date of purchase and your customer account number ready. 4. A Representative will assist you. He or she will try to troubleshoot any problem you may be having.
  • Page 31 Notes 104333...
  • Page 32 Notes 104333...

Table of Contents