Page 1
BOOK# 091-26-12, 4-23-97 INSTRUCTION MANUAL AUTO CHARGE 3 AUTOMATIC BATTERY CONDITIONER MODEL #091-26-12 NOTE: THIS IS A CONDITIONER FOR MAINTAINING THE CHARGE IN A VEHICLE'S BATTERY. IT WILL RECHARGE THE BATTERY SLOWLY BUT IS NOT RECOM- MENDED FOR APPLICATIONS WITH AUXILIARY LOADS.
Page 2
INTRODUCTION The Auto Charge 3 Automatic Battery Charger is a compact, completely automaticcharger designed for installation on vehicles with two batteries. An internal charge divider charges both batteries simultaneously while maintaining complete battery isolation. A maximum output of 3 amperes privides sufficient current for vehicles which do not have large constant accessory loads.
INSTALLATION WIRING DIAGRAM IMPORTANT: Wire size is for a WIRE SIZE CHART maximum length of 40 feet. If wiring is to be longer, larger wiring is re- CONNECTION ITEM DEFINITION WIRE SIZE BATTERY NEGATIVE CHARGING LEAD 14 AWG quired. Additional information is COMMON FOR BATTERIES available on request.
SPECIFICATIONS SPECIFICATIONS: Input: 120 Volts, 60Hz, 1 amp Output Volts: 13.25 volts nominal Output Current: 0-3 Amps D.C. output current determined by state of charge of batteries Charge Indicator: RED LED indicates charging current GREEN LED indicates fully charged Remote Charge Indicator Connector: permits locating Red/Green LED's at remote loaction Weight: 6 lbs OUTLINE DRAWING...
Vehicle Identification Vehicle Owner WARRANTY All product of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped.