Table of Contents
Advertisement
Multi-car control capability
You can operate the Responder LE 2-way remote control system for two
cars, with full command capability for both vehicles.
While holding a command button and transmitting, the Amber LED at
the top of the remote control will blink in groups to indicate which Car
is being controlled.
▀
Car 1: 1 blink
▀
Car 2: 2 blinks
To change the Car to be operated:
Press/hold the
the
and/or
currently operates.
▀
Car 1: 1 beep and Arm LED on
▀
Car 2: 2 beeps and Arm & Disarm LEDs on
Change Car: While the LEDs are on Press and release the
LEDs will change to indicate the car that can be operated. Once the car
number is selected you can press any command button to operate the
system. The selected car remains selected until the setting is changed.
Adjusting the onboard shock sensor
The new Responder LE system has an onboard shock sensor that is
remote adjustable. Adjusting the onboard sensor can be performed
by an authorized dealer (recommended) or by a programmed remote
transmitter.
Transmitter adjustment:
Disarm the unit and exit Valet Mode if ON. Turn the ignition off and
close all entry points (door, hood, trunk).
Use the following steps to put the control module into sensor
© 2008 Directed Electronics—all rights reserved
button for 3 seconds or until the remote beeps and
LEDs turn on. This will indicate which car the remote
A U
X
2
3
4
5
6
button. The
Hide quick links:
Advertisement
Table of Contents
