Table of Contents
Advertisement
System maintenance
The system requires no specific maintenance. Your remotes are pow-
ered by small coin cell lightweight 3-volt lithium batteries that will
last approximately one year under normal use. The 2-way remote
uses two CR2016 cell batteries and the 1-way remote uses one
CR2032 cell battery. When the battery begins to weaken, the oper-
ating range will be reduced.
Low battery indicator
When the batteries are low on the 2-way remote it will emit two
groups of beeps, the
additional chirp to let you know its time to change the battery.
When the battery is low on the 1-way remote, the remote responds
the same, but without the LED flash.
Note: The Arm/Disarm chirps should be programmed ON for the
alarm to emit any additional chirps during disarm. Ask your
authorized dealer if you have any questions.
Battery Replacement
Press tab to release tray and pull out to expose the battery in
the holding tray. Remove the expired battery. Place the new bat-
tery into the remote control. When power is returned the remote
control is ready for use. This tab is small and recessed and may
require a small flat object such as a jeweller's flathead screwdriver
to unlatch.
0
LED will flash, and the alarm will emit an
© 2008 Directed Electronics—all rights reserved
Hide quick links:
Advertisement
Table of Contents
