DirecTV D10-300 User Manual page 10

TV
Unplug all equipment from the AC outlet before making connections.
There are several options for connecting the video and audio outputs of your DIRECTV® Receiver, depending on the type
of equipment you want to connect and the quality of signal you want to achieve.The following chart summarizes your options
for video connections. Select either A, B, or C and refer to the illustration and steps below to connect.
Option Video Signal Quality
A Very Good
B Good
C Standard
Note : The TV rear panel shown above has jacks for all possible connections.Your TV's rear panel may differ.
A. Using a S-VIDEO cable (supplied), connect one end to the S-VIDEO connector on the Receiver to the S-VIDEO IN
on the TV. Select the proper input on your TV.
B. Using the RCA type cable (supplied), connect one end to the OUT 1 VIDEO jack (yellow) on the Receiver to the VIDEO
IN on the TV. Select the proper input on your TV.
C. Using the RF coaxial cable (not supplied), connect one end to the OUT TO TV connector on the Receiver to the RF IN
jack on the TV.Turn the TV on and select channel 3 or 4, whichever is not used or least used in your area. Set the CHANNEL
switch on the back of the Receiver to the same channel.
Note : If only one plug is connected on either left or right mono audio output will be delivered by your DIRECTV
Connections (cont'd)
Video Output
S-VIDEO OUT
VIDEO OUT 1
RF - OUT to TV
10
receiver
®