Operating Instructions - GRAUPNER SWITCHING POWER SUPPLY 5-15V 0-40A Manual

Order.-Nr. 6490 SWITCHING POWER SUPPLY 5 - 15V 0 – 40A
Wide Adjustable Output Area
Introduction
Please be sure to read right through these operating instruction attentively before you
attempt to use your new switching power supply, as this will ensure that you can make full
use of all of its facilities. Take particular note of the warnings and safety notes. These
instructions should be kept in a safe place; if you ever dispose of the charger be sure to pass
them on to the new owner.
This power supply is small, lightweight, compact, provided with a current limiter, a
universal output for 4mm banana plugs and an automatic current regulator. At the same time,
it is suitable for giving power or testing your equipment. It's also provided with a protection
circuitry to prevent any damages to the unity or your equipment in case of malfunctioning to
high-voltages. Fitted out with a cooling system that guarantees a constant full operatively to
the unit and prevents from overheating. This power supply is perfect to supply 12V chargers
and DC mini drills. This power supply can also be used as a Pb charger.
1. Specification:
Input Voltage: 220~240V AC 50Hz
Input Plug: SCHUKO plug
Output Power: 600W
Output Connection: 4mm Banana Clamp
Output Voltage: 5V~15V DC (adjustable)
Output Current: 0~40A (adjustable)
Size: 260×190×105mm
2. Features:
Over power protection, short circuit protection
Inner cooling system by fan
Adjustable maximum power output
Pw =Vo×Io
Vo: output voltage (adjustable)
Io: output current in short circuit (adjustable)
LC displaying output voltage and current

3. Operating Instructions:

1. Using as a common DC power supply: plug in, adjust the voltage knob to get your
needed value (5~15V). The voltage is displayed on the LCD.
Then turn the Amp knob to get your needed max current cut off point.
The LCD will show you the current.
2. Read thoroughly the following contents before using.
3. Disconnect the power supply from AC mains power before connecting device to the
power supply.
4. Connect the device to the power supply ensuring the correct polarity. Red is positive.
Black is negative and ensuring good contact.
Constant Current