PRESONUS DIGIMAX User Manual page 12

authorized PreSonus dealer or which can be ordered directly from
PreSonus. S/PDIF outputs can also be obtained from an Authorized
PreSonus dealer by purchasing a Model No.510-DMAX008 cable or by
ordering the cable from PreSonus. The use of the S/PDIF output requires
re-configuring the jumpers on the output card of the DigiMax. While this is
a simple operation, care must be taken when moving the jumpers.
diagram and complete instructions regarding this procedure are included
with the 510-DMAX008 cable. Should you need further assistance, contact
Customer Support at PreSonus by calling 800-750-0323 between the hours
of 10:00 AM and 5:00 PM CST
The Word clock output and input are accessed through
Word Clock Out/In.
separate BNC connectors. The internal sample rate can be set to send 32k, 44.1k,
or48k. The Word Clock In scans the incoming information and automatically
synchs to the necessary sample rate.
+48V. A switch labeled +48V is located next to each microphone
input. This switch may be engaged to provide phantom power for
condensor mics and any other device, which may require phantom
by way of the XLR input. This power is supplied at a constant rate to allow
power
use of all eight inputs, simultaneously, without any degradation of audio quality.
XLR connector wiring for Phantom Power
ANALOG OUTPUT. Each channel of the DigiMax has an analog
output that parallels the digital signal being sent from the
associated channel. This output can be very useful for monitoring
purposes by helping in overcoming the time discrepancy that may
be encountered in some digital recording situations. This output is
impedance balanced and the connection is wired as follows:
PIN 1 GND
PIN 2 +48v
PIN 3 +48v
TIP Signal
11
51ohms
A