Steps For Connecting - Epson BrightLink 455Wi Operation Manual

Two Connection Modes

Steps for Connecting

Use the following steps to connect the computer to the projector and
project in EasyMP Network Projection.
To connect the computer and the projector via a network with EasyMP
Network Projection, connect in Advanced Connection Mode. Advanced
Connection Mode is an infrastructure connection, and connects to an
existing network system via a network cable. When connecting to a
network, connect the projector to the network hub with a commercially
available LAN cable.
You need to perform steps 1 to 4 only the first time you connect.
1. Install EasyMP Network Projection on the computer to be connected.
p.6
s
*
2. Make network settings on the computer and put it into network
connection status. s p.11
3. For Quick Connection Mode: Install the optional Wireless LAN unit
in the projector (if already installed, go to step 5).
For Advanced Connection Mode: Enable the Wired LAN or Wireless
LAN adapter in "Port Configurations". s Computer's documentation
4. Make network settings on the projector and put it into network
connection status. See your projector User's Guide for details.
5. Start EasyMP Network Projection on the computer and connect with
the projector. s p.12
* When the computer you are using is normally connected to the network,
you do not need to make network settings on the computer.
10