Epson BrightLink 455Wi Operation Manual page 41

An e-mail notifying the operator of a problem/warning/status is issued
The details contained in the e-mail message can consist of the following.
Message
Internal Error See your User's Guide for more information.
Fan error
Sensor error
Lamp Cover Open
Lamp failure at power
*
on
*
Lamp Error
Supply System Error
*
(Ballast)
High internal
temperature error
Low air flow error
Air filter air flow
sensor error
Cinema filter error
Shutter error
Cooling system error
(Peltier element)
Cooling system error
(pump)
High-temperature
warning
*
Replace Lamp
*
Lamp error
Lamp failure at power
*
on
Remedy
Message
Supply System Error See your User's Guide for more information.
*
(Ballast)
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
Cinema filter warning
Shutter warning
Clean Air Filter Notice
No signal No image signals are being received by the
projector. Check the connection status and check
that the power for the connected equipment is
turned on.
Other error Stop using the projector, disconnect the power
cable from the electrical outlet, and contact Epson.
Auto Iris Error
See your User's Guide for more information.
Network error (TCP Check the following items.
connection error)
Check that the projector's power is turned on.
Check that the LAN cable is connected.
Check that Standby Mode is set to Communication
On (or Network On) or Network Monitoring is set to
On in the projector's configuration menu.
See your User's Guide for more information.
Network error Check that the projector has been correctly
(ESC/VP.net connected to the network. See your User's Guide for
communication error) more information.
Network error Check the projector's Monitor Password.
(Monitor Password
authentication error)
41
Remedy