How To Disassemble The Set - LG RD-JT30 Service Manual

1. Lamp Module
The lamp module is located at bottom of the projector. The lamp module behinds
the lamp cover with 1 captive screw. After you replace the lamp module, you should
reset the lamp hour counter. The switch interrupts power supply output to the projector
if you remove the lamp cover.
WARNING Allow the projector to cool before removing the lamp module. The lamp module becomes
very hot when the projector is in use. DO NOT touch any part of the lamp module that is
located in the lamp box. Oils from your fingers will cause smudges and uneven heating of
lamp surfaces, resulting in decreased image quality and premature lamp failure. If the lamp
is ruptured or the lamp module is cracked or damaged, be careful of quartz or glass
fragments that could cause personal injury.
1.Remove two screws of lamp cover which is a spring door.
2. Remove the 1 screw from the lamp module.

10. How to disassemble the set

23