Directed Electronics Clifford G4203X Owner's Manual page 8

➢ Battery Replacement
Note:
Verify that the battery polarity is correct when replacing.
Batteries are stacked in series and polarity is indicated.
3. Reposition all parts and snap together
8
Elastomer
1. Using a small slotted screw-
contact
driver, insert into slot located on
the side of the unit as shown and
carefully pry the front of the unit
up, working your way around the
edge until the front is completely
separated from
Front
Note:
Make sure that the small elas-
tomer contact located inside the unit
as shown does not fall out during the
replacement process.
2. Turn the circuit board over,
remove batteries from clip and re-
Elastomer
contact
place.
the housing.
© 2008 Directed Electronics. All rights reserved.
Front
Front
Elastomer
contact
Elastomer
contact
Circuit Board
+ +
+
Front
Elastomer
contact