Arming While Driving - Directed Electronics Viper 771XV Owner's Manual

Directed electronics combination remote start alarm system owner's manual 771xv
Hide thumbs Also See for Viper 771XV:
Table of Contents

Advertisement

Press
times followed by a long chirp. Zones 2 and 4 are now bypassed.
Press
five times followed by a long chirp. All input zones, except
the ignition, are now bypassed.
note: Multi-Level Security Arming only applies to a sin-
gle arming cycle. Once the system is disarmed and then
re-armed, all the zones will be active again.
After each press of the
remote will emit normal arm notification (1 beep and 3 flashes of
the Orange LED). For easiest operation in reaching each level of
security, press

arming while driving

Your security system can be armed while driving the vehicle!
Simply press
vehicle is running. The siren will chirp once to indicate that the
security system is armed, and then once more to indicate that the
ignition is on. The system will not respond to any input except the
door triggers, and the starter kill relay (if installed) will not be acti-
vated. Once you have arrived at your destination, the system can
be disarmed by pressing the
The siren will chirp twice and the in-vehicle status LED will then
stop flashing. The system can also be disarmed at any time by
pressing
18
a fourth time within five seconds: The siren chirps four
a fifth time within five seconds: The siren chirps
to reach the next level of security, the
immediately a a f f t t e e r r each notification.
on the 2-way remote for two seconds while the
. .
or by turning the ignition Off.
© 2005 directed electronics—all rights reser ved

Advertisement

Table of Contents
loading

Table of Contents