Rapid Resume Logic; Power Saver Mode - Directed Electronics 460MAX Owner's Manual

Rapid resume logic

This Directed system will store its current state to non-volatile mem-
ory. If power is lost and then reconnected, the system will recall
the stored state from memory. This means if the unit is in Valet
Mode and the battery is dis con nect ed for any reason, such as
servicing the car, when the battery is re con nect ed the unit will still
be in Valet Mode. This applies to all states of the system including
arm, disarm, VRS

Power saver mode

Your system will automatically enter Power Saver Mode while
armed or in Valet Mode, after a period of time in which no op-
eration has been performed. This lowers the current draw to the
vehicle's battery. Power Saver Mode takes over under the follow-
ing conditions:
• Power Saver when the system is armed: After the system has
been armed for 24 hours, the LED will flash at half its normal
rate, decreasing the system's current draw.
• Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.
22
, and Valet Mode.
®
© 20 0 8 D i re cte d E l ec tro n i cs- Al l ri g ht s res e r v e d.