Table of Contents
Advertisement
Quick reference guide
To arm using your remote
You can activate, or arm, the system by pressing
on your transmitter for one
second. When the system arms, you will hear a short siren sound, or chirp, and the
parking lights will flash once. If the vehicle's power door locks have been
connected to the system, the doors will lock.
�������
To disarm using your remote
To disarm the system, press
. You will hear two chirps, and the parking lights
will flash twice. If power locks are connected to the system, the doors will unlock.
If the siren chirps either four or fve times when disarming, see Diagnostics section.
�������
This is called Tamper Alert.
Arming while driving
Press
on your transmitter for two seconds while the vehicle is run ning. The system
will chirp once and then once more to indicate that the ig ni tion is on.
Disarming without a transmitter
�������
Turn on the ignition. Press the Valet switch the programmed number of times within
15 seconds. The sys tem should now disarm. If it does not, you may have waited too
long. Turn the ignition off and on and try again.
To enter or exit Valet Mode
Turn ignition to RUN position, then turn to OFF position. Press and release the Valet
switch within 10 seconds. The status LED will light solid if you are en ter ing Valet
Mode, and it will go out if you are exiting Valet Mode.
To activate Panic Mode
Press and hold
down for one second.
To exit Panic Mode
Press
on the transmitter.
To activate Silent Mode™
Press
briefly before arming or disarming, and the con fr ma tion chirp(s) will be
�������
eliminated for that one op er a tion only.
_______________________________
Location of Valet switch
Number of Valet switch pulses for disarming_____________
35
© 2 0 0 8 D i re ct ed E l e ct r o ni c s - A l l r i g ht s re s e rv e d.
Advertisement
Table of Contents
