Rapid Resume Logic - Directed Electronics Python 3000 ESP Installation Manual

2.
To disarm the VRS (before the siren starts to chirp):
1.
2.
To disarm VRS (after siren has started to chirp):
1.
2.
NOTE: When the VRS is used, it is highly recommended to program the unit for Ghost Switch only
disarm mode. For a detailed explanation of the VRS triggered sequence, refer to the Vehicle Recovery
System section of the Owner's Guide.

rapid resume logic

When power is lost or disconnected, the security system will power back up in the same state it was in before
power was lost. For example, if power is disconnected during a full trigger sequence, when power is reconnected
to the unit it will remain in the full trigger sequence. If power is disconnected while the unit is disarmed, the
unit will still be disarmed when power back up . This also applies to the VRS sequence. If the unit loses power
at any time during the VRS sequence, when the unit is powered back up it will automatically go to the VRS full
trigger sequence.
38
Press the arm button for 1 second. The parking light will flash once and the siren will chirp
once to confirm that the VRS system is armed and will enter the trigger sequence next time
a door is opened then closed.
Turn the ignition to the ON position.
Press the arm button for 1 second. The parking lights will flash twice and the siren will
chirp twice to confirm that the VRS system is disarmed.
Turn the ignition to the ON position.
Press and release the Valet/program switch. If programmed for Ghost Switch only mode,
press the Ghost Switch the programmed number of times to disarm the VRS. This step must
be performed within 10 seconds of turning the ignition switch on.
© 2001 Directed Electronics, Inc. Vista, CA