Magnifying And Searching For Details - BenQ CP270 - XGA DLP Projector User Manual

Digital projector
Table of Contents

Advertisement

Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the
top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following one of these steps.
Using the remote control
Press
/
to display the Keystone correction page. Press
to correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the
image.
Using the OSD menu
1.
Press Menu/Exit and then press
DISPLAY
the
2.
Press
Mode/Enter. The Keystone correction page
displays.
3.
Press
the image or press
at the bottom of the image.

Magnifying and searching for details

If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
Using the remote control
1.
Press Digital Zoom +/- to display the Zoom
bar.
2.
Press Digital Zoom + to magnify the center of
the picture. Press the key repeatedly until the
picture size is suitable for your need.
3.
Use the directional arrows ( ,
the projector or remote control to navigate the
picture.
4.
To restore the picture to its original size, press
AUTO. You can also press Digital Zoom -. When the key is pressed again, the picture is
further reduced until it is restored to the original size.
Using the OSD menu
1.
Press Menu/Exit and then press
2.
Press
3.
Repeat steps 2-4 in the section of
the projector control panel, continue to the following steps.
4.
Press
5.
To navigate the picture, press Mode/Enter to switch to the paning mode and press the
directional arrows ( ,
28
Operation
on the projector or remote control
menu is highlighted.
to highlight Keystone and press
to correct keystoning at the top of
to correct keystoning
to highlight Digital Zoom and press Mode/Enter. The Zoom bar displays.
on the projector repeatedly to magnify the picture to a desired size.
,
/
until
Press
,
,
) on
/
until the DISPLAY menu is highlighted.
"Using the remote control"
,
) to navigate the picture.
/ .
Press
above. Or if you are using
/ .

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp270

Table of Contents