Table of Contents
Advertisement
Emergency Calls
Your phone was programmed with an
emergency number (911) when it was
manufactured. The programmed emergency
number can be dialed and called at any time, if
there is a 911 system available, regardless of
any call restrictions you have set through the
Locks menu (see page 27). A representative
from your service provider or the retail outlet
where you purchased your phone should be able
to change the emergency number in your phone,
if a 911 system is not available in your service
area.
If police, fire, or medical help is needed, dial 911
or your emergency number and press Y. Tell
the dispatcher that you are calling from a
wireless phone. Wireless 911 calls do not
automatically provide emergency personnel
with your name, location, or phone number.
The dispatcher will want to know the following:
1. Your name and wireless phone number.
2. The nature of the emergency.
3. If police, fire, or medical assistance is needed.
4. The exact location of the emergency
including cross streets, mileposts, or
landmarks.
5. How many people are involved, their
condition, and if help is being administered.
International Calls
If allowed by your system, you can place
international calls with your phone just as you
would from any other phone. If you have
Display Messages
Call Receive
Dialing
InUse
Call MM:SS
Low Battery
System Busy!
Scanning...
## Calls
Mic Muted
Phone Locked
Keypad Lock
Call is Restricted
Charging Only
Charging Complete
Silent
difficulty completing international calls, check
with your system operator for information.
Caller Number Identification
If your system provides Caller ID service, your
phone shows the phone number of an incoming
call in the display. Also, if the number is one
that you have stored in memory with a name,
the name is shown with the phone number
when your phone rings. If the Caller ID
information is not available, the message
NO ID
is shown in the display. The word
Private
restricted by the system.
Low Battery Power Alert
The low battery alert sounds when your battery
is reaching its lowest operational power level.
The words
display, and the indicator light on top of your
phone flashes red. When this happens, leave
your phone turned ON. The phone discharges
the battery and then shuts itself OFF. You
should charge the battery within 24 hours so
that the battery can charge to full capacity.
Security Code
Your phone has a security code that you must
enter to gain access to certain functions, such as
call restrictions and calling card numbers. The
factory-programmed code is 0000. You should
change this code to provide maximum security
for your phone.
Your phone is receiving a call.
Your phone is dialing the number shown in the display.
You have a call active.
The elapsed time of your active call, in minutes and seconds.
The battery is reaching its lowest operational power level.
Your system has no channels available. Try again later.
The phone is searching for a system.
The number of calls you have not answered.
The microphone is muted.
The phone is locked to prevent unauthorized use.
The keypad is locked to prevent unauthorized use.
You attempted to call a phone number that is restricted in
the Locks menu.
The phone is in charge-only mode and will not make or receive calls.
Charging is finished.
The phone ringer is muted.
Basic Operations
may be shown if the caller ID is
Low Battery
flash in the
9
Advertisement
Table of Contents
