Turning The Power Off - Edirol VC-50HD SDI 1394 Owner's Manual

Turning the power off

Slide the POWER switch in the direction of the arrow and hold it for two or three
seconds until the POWER indicator goes out.
If mode select switch 6 is on, so that remote control is activated, operating the POWER switch
will not turn off the power. To turn off the power, disconnect the power cable.
Mode select switch 6 is the remote control setting. For details on remote control, refer to "Accepting
remote control" (p. 28).
Caution regarding the power supply
* If you're using an external battery without installing AA batteries internally, the VC-50HD's power will be
turned off if you disconnect the power cable from the DC IN connector. Simply reconnecting the power cable
to the DC IN connector will not turn the power on again. You will need to use the POWER switch to turn on
the power.
* Before making connections to other devices, turn off the power of all devices to prevent malfunction and/or
speaker damage.
* Depending on the circumstances of your installation, you may experience an unexpected sensation of
roughness when you touch a metallic component of the VC-50HD or of a connected monitoring device or deck.
This is due to an infinitesimal electrical charge, which is absolutely harmless. If you are bothered by this, you
can connect the grounding terminal shown below to an electrical ground. If this is connected, a slight amount
of noise may occur depending on the conditions of use.
If you are not sure how to make this connection, please contact Roland service.
fig.earth-terminal.eps
Do not connect this to locations such as the following:
• Water pipe (may cause electrocution)
• Gas pipe (may cause explosion or fire)
• Telephone ground or lightning rod (hazardous during lightning)
Turning the power on/off
21