Edirol VC-50HD SDI 1394 Owner's Manual page 19

3.Fasten the battery plate and holder to the top of the VC-50HD
Using the four included screws, fasten the battery plate and holder that you assembled in step 1 to
the top surface of the VC-50HD.
* Use caution, since excessive tightening may damage the VC-50HD.
fig.fix-holder.eps
4.Attach the external battery
Attach the external battery, and connect its power cable to the VC-50HD's DC IN connector.
fig.connect-battery.eps
The eight screws included with the VC-50HD are only for attaching the battery plate holder. The four
screws removed from the top surface of the VC-50HD cannot be used for this purpose. When attaching
an external battery, be aware of the different types of screws.
fig.bolts.eps
Screws for fastening
Regarding the external battery
The VC-50HD is compatible with external batteries that produce an output voltage in the range of 9
volts to 20 volts. Please use a product that falls within this range.
A fully charged ENDURA-10 (E-10) made by the IDX Company, Ltd. will provide approximately ten
hours of continuous operation.
* The continuous operating time will depend on the temperature and other conditions of use.
Removed screws
Power supply
19