Setting Up The Security Appliance - Cisco 515E - PIX Restricted Bundle Getting Started Manual

Chapter 1 Installing and Setting Up the PIX 515E Security Appliance

Setting Up the Security Appliance

Note
78-17645-01
Figure 1-4 PIX 515E Security Appliance Back Panel
100 Mbps
LED
ACT
LED
100 Mbps
ACT
10/1 00 ETH ERN ET 1
10/100BaseTX
ETHERNET 1
(RJ-45)
This section describes the initial configuration of the security appliance. You can
perform the configuration steps using either the browser-based Cisco Adaptive
Security Device Manager (ASDM) or the command-line interface (CLI).
However, the procedures in this chapter refer to the method using ASDM.
To use ASDM, you must have a DES license or a 3DES-AES license. For more
information, see Appendix A, "Obtaining a DES License or a 3DES-AES
License."
This section includes the following topics:
About the Factory-Default Configuration, page 1-6
•
• About the Adaptive Security Device Manager, page 1-6
Using the Startup Wizard, page 1-7
•
100 Mbps
LED USB
LINK
ACT
LINK
LED
LED
LED
LINK
100 Mbps
ACT
LINK
10/1 00 ETH ERN ET 0
USB
10/100BaseTX
ETHERNET 0 port (RJ-45)
(RJ-45)
PIX 515E Security Appliance Getting Started Guide
Setting Up the Security Appliance
FAILO VER
CON SOL E
Console Power switch
1-5