Table of Contents
Advertisement
Attach one M2.03 x 3.0 screw at point (A) and 14 M2.0 x 6.0 screws to the screw holes marked
3.
below to secure the upper case to the lower case.
With the connector clips down, connect the touchpad cable connector to the mainboard
4.
connector with the metallic contacts side up. Then push the connector clips up to lock.
Install the HDD module (see
5.
Install the fan (see
6.
Install the DIMM module (see
7.
5-37
Figure 5:48. Securing the Upper and Lower Case Screws
Figure 5:49. Connecting the Touchpad Cable
HDD Module Installation
Fan Installation
DIMM Module Installation
A
on page 5-16).
on page 5-23).
on page 5-26).
Service and Maintenance
Advertisement
Table of Contents
