Advertisement
2005 Triad II Specifications
Sequencer valve
compartment
26 in [67 cm]
Recommended location for
Electrical
Inlet
10 in [27 cm]
Hose Bib/
Water Drain
Front Side of Spa
Hose Bib/
Water Drain
3 1/2 in [9 cm]
Note: 1. Subject to change without notice.
2. Engineering specs may differ slightly from brochure.
3. For E-Z lifter installation allow 18" (45.7cm) clearance on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer for exact details
5. This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa.
Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.
Doc-1215 Rev -B Rev Date: 1/31/05
2005 Triad II
Architectural Specification
THIS 3 FOOT SQUARE AREA,
ON BOTTOM OF SPA, TO BE
SUPPORTED CONSISTENT WITH
THE EDGES OF SPA BASE.
Control Panel
Control
Pedestal Base
Door Extends
Under Spa Lip
Specification, 2005, Triad II
16 in [41 cm]
Equipment
Compartment
Vent
Vent
25 1/2 in [64 cm]
36 1/2 in [92 cm]
47 in [119 cm]
58 in [147 cm]
83 1/2 in [212 cm]
Spa Lip
67 in [170 cm]
83 in [210 cm]
R16 in [R41 cm]
R16 in [R41 cm]
16 in [41 cm]
63 1/2 in [162 cm]
Pedestal
Base
Vent
30 1/2 in [77 cm]
26 1/2 in [67 cm]
Dimension One Spas
66 1/2 in [169 cm]
Shell
See Caution
66 in [168 cm]
Skirt
Page 2 of 2
Advertisement
