Kurzweil K2600 ROM - INSTALLATION REV E Installation Manual page 7

Figure 2 shows how you would insert the SD Piano ROM option card into the ROM 3
connectors (the procedure is similar for all the option cards). In the figure, you're looking at the
top of the option card; the connectors are on the underside. After making sure the arrows point
in the same direction, align the connectors on the option card with those on the daughter board.
Keeping the card as level as possible, press the card into the connectors on the daughter board. It
should be relatively easy to press the card into place (about the same amount of pressure it takes
to eject a disk from the K2600's floppy drive). If the card doesn't pop into place easily, check the
connectors on the daughter board to make sure there aren't any bent pins.
Figure 2 Daughter board, showing connectors for options
2. Replace the access panel and loosely install the screws, starting with those closest to the
hinge (back) of the access panel. When the screws are loosely in place, tighten them all,
then turn the K2600 right side up. This completes the "hardware" portion of the
installation.
3. Reconnect the power cable. The next part of the installation is to install the object files, as
described in the following section.
Installing Kurzweil K2600 ROM Options
Installing ROM Option Cards (Keyboard or Rack-Mount Models)
7