Kurzweil K2600 ROM - INSTALLATION REV E Installation Manual page 5

1. Unplug all external wires, cables, and connectors from the K2600 and turn it so the
keyboard faces you.
2. Turn the K2600 upside down by lifting the front edge and rotating it away from you. Rest
the front panel on two three-inch thick foam pads (or similar soft items like pillows).
These pads will prevent damage to the K2600's sliders and Alpha Wheel.
3. Using a #2 Phillips screwdriver, remove the eight screws attaching the access panel. Set
the access panel and screws aside for reassembly.
4. Remove the adhesive strip backing from the thick piece of foam supplied in the RMB-26
kit (the thin piece is for installation in rack-mount models, and you won't need it). Attach
the foam over the cross-hatched area on the access panel.
5. Locate Connector J809 (labeled ROM EXP) and the three standoffs (white plastic pins that
stick straight up) on the CPU board. See Figure 1.
6. Align the ROM option daughter board so that Connector J1201 on the daughter board
lines up with Connector J809 on the CPU board. The three holes in the daughter board
should line up with the standoffs on the CPU board.
7. Press down on the ROM Option Daughter Board to attach it to the connector and
standoffs on the CPU board. The board will snap into place on the three standoffs.
8. Turn to page 6, and proceed with the instructions for installing ROM option cards.
Figure 1 K2600 CPU Board
Installing Kurzweil K2600 ROM Options
Installing the Daughter Board
5