Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 14 Sampling Manual page 14

Sampling and Sample Editing
Editing Samples
The default values shown in this diagram reßect the settings for the Default program 199.
EditRomSample:MISC||||||||||||||||||||||
RootKeyNum||:C|4||||LoopSwitch:On|||||||
PitchAdjust|:1ct||||Playback||:Normal|||
VolumeAdjust:0.0dB||AltSense||:Norm|||||
AltVolAdjust:0.0dB||IgnRelease:Off||||||
DecayRate|||:950dB/|SampleSize=0Kb||||||
ReleaseRate|:950dB/|SampleRate=1000Hz|||
<more|||MISC|||TRIM|||LOOP|||Link||more>
Parameter
Root Key Number
Pitch Adjust
Volume Adjust
Alternative Volume Adjust
Decay Rate
Release Rate
Loop Switch
Playback Mode
Alternative Sample Sense
Ignore Release
Root Key Number
The root key number represents the key at which the sample will play back without
transposition (that is, at the same pitch as the pitch of the original sample). When youÕre creating
your own samples, the key you strike as the root key will be the key you see as the value for this
parameter.
Pitch Adjust
Use this parameter to change the pitch of the sample relative to the key from which itÕs played.
Setting a value of 100cts, for example, will cause the sample to play back one semitone higher
than normal. This parameter is handy for Þne tuning samples to each other if theyÕre slightly out
of tune.
Volume Adjust
Uniformly boost or cut the amplitude of the entire sample. Compare this to the DSP Volume
Adjust parameter, which lets you boost or cut the amplitude of a speciÞed segment of a RAM
sample.
Alternative Start Volume Adjust (AltVolAdjust)
This parameter sets the amplitude of the sample when the alternative start is used. See page 6-26
for a discussion of AltSwitch.
14-14
Range of Values
C -1 to G 9
Variable (depends on sample rate)
-64.0 to 63.5 dB
-64.0 to 63.5 dB
0 to 5000 dB per second
0 to 5000 dB per second
Off, On
Normal, Reverse, Bidirectional
Normal, Reverse
Off, On