Yamaha Clavinova CLP-430 Owner's Manual page 86

4.
Connect the power cord.
4-1
For models that feature a voltage selector:
Set the voltage selector to an appropriate
voltage.
4-2
Insert the AC power cord plug into the power
connector.
Right leg on the bottom of the main unit, when viewed
from front
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
"minus" screwdriver to rotate the selector dial so that the
correct voltage for your region appears next to the pointer on
the panel. The voltage selector is set at 240V when the unit is
initially shipped.
After the proper voltage has been selected, connect the AC
power cord to the [AC INLET] and an AC wall outlet. A plug
adaptor may be also provided in some areas to match the pin
configuration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to
the instrument or result in improper operation.
5.
Set the adjuster.
Rotate the adjuster until it comes in firm
contact with the floor surface
Appendix
86
Assembling the Clavinova
4-1
4-2
6.
Attach the headphone hanger.
Use the included two screws (4 x 10 mm) to
attach the hanger as shown in the illustration.