Yamaha Clavinova CLP-430 Owner's Manual page 77

1.
Attach D to E and F.
1-1
Attach D to E and F by using four long screws
(6 x 20 mm).
1-2
Secure D from the rear using two long screws
(6 x 20 mm).
1-3
Remove the twist tie from the folded pedal cord.
Do not remove the twist tie that is located next
to the hole.
F
D
1-2
2.
Temporarily mount B.
2-1
Insert B between E and F as shown in the
illustration.
2-2
Align and attach B to the front side of D, E and F.
2-1
F
D
1-1
1-3
E
2-2
B
E
2-3
Temporarily secure B by finger-tightening four
long screws (6 x 20mm).
* Insert four screws into the larger holes (all four holes) on the
brackets.
2-4
Secure B using a thin screw (4 x 14 mm).
* Insert the screw into the smaller hole on the bracket.
2-3
3.
Mount A.
3-1
Place your hands at least 15 cm from either end
of A to mount it.
3-2
Position A so that the stopper-wood on the rear
side of the bottom of A will be located behind
the front panel, then slide A slowly toward the
rear while lightly pushing E and F toward the
center.
* Be sure to slide the guide pins
guide slots on E and F respectively.
15 cm or
3-1
further in
F
3-2
CAUTION
Be extra careful not to drop or let your fingers be pinched by the
main unit.
CAUTION
Do not hold the main unit in any position other than the position
specified above.
2-4
on each side of A into the
A
E
15 cm or
further in
Appendix
Assembling the Clavinova
77