Kyocera KM-1530 Instruction Handbook Manual page 112

3. Printer Driver for Macintosh
I Staple:
It is possible to staple your copy sets if the optional Finisher is installed.
* Stapling is only available with 20 ppm copiers.
* The following settings are required before stapling is possible:
(1) Change the "Installable Options" setting in step 9 on page 3-3 to the following.
Select "Finisher" as the "Output Device" setting and "RAM Disk" under "Optional Disk".
(2) "Printer Specific Options" setting on page 3-6.
Select "Finisher" as the "Output Bin" setting and "On" under "Sort".
* Paper sizes, types and source of paper feed that are acceptable for stapling are as follows:
Paper sizes: Letter (8 1/2" x 11"), Legal (8 1/2" x 14"), Tabloid (11" x 17"), A3, A4, JIS B4 and JIS B5
Paper types: Plain, Letterhead, Recycled and Color
Source of paper feed: Any tray EXCEPT the Bypass Tray
I Sort:
Allows you to select whether to sort the copies in the case of multiple copy.
[Off] ........................................... Does not sort.
[On] ............................................ Prints in the order of 1st, 2nd, 3rd copies and so on.
* It is necessary to create a RAM disk. (Refer to step 10 on page 3-3.)
* If you selected any of the "Staple" settings above, it is necessary to select "On" here.
I 180 Rotate:
Selecting this option prints upside down.
3-7