Dell PowerConnect M6220 Configuration Manual page 40

console(config)#lldp notification-interval 1000
console(config)#lldp timers ?
hold
interval
reinit
<cr>
console(config)#lldp timers hold 8 reinit 5
console(config)#exit
Example #2: Set Interface LLDP Parameters
The following commands configure the Ethernet interface 1/g10 to transmit and receive LLDP
information.
console#configure
console(config)#interface ethernet 1/g10
console(config-if-1/g10)#lldp ?
notification
receive
transmit
transmit-mgmt
transmit-tlv
console(config-if-1/g10)#lldp receive
console(config-if-1/g10)#lldp transmit
console(config-if-1/g10)#lldp transmit-mgmt
console(config-if-1/g10)#exit
console(config)#exit
Example #3: Show Global LLDP Parameters
console#show lldp
LLDP Global Configuration
Transmit Interval............................ 30 seconds
Transmit Hold Multiplier..................... 8
Reinit Delay................................. 5 seconds
Notification Interval........................ 1000 seconds
Example #4 Show Interface LLDP Parameters
console#show lldp interface 1/g10
LLDP Interface Configuration
40
Switching Configuration
The interval multiplier to set local LLDP data TTL.
The interval in seconds to transmit local LLDP data.
The delay before re-initialization.
Press enter to execute the command.
Enable/Disable LLDP remote data change notifications.
Enable/Disable LLDP receive capability.
Enable/Disable LLDP transmit capability.
Include/Exclude LLDP management address TLV.
Include/Exclude LLDP optional TLV(s).