Dell PowerConnect M6220 Configuration Manual page 18

Example #1: Viewing SNTP Options
(Dell PC62XX Routing)(Config) #sntp ?
console(config)#sntp ?
authenticate
authentication-key
broadcast
client
server
trusted-key
unicast
Example #2: Configuring the SNTP Server
console(config)#sntp server ?
<ipaddress/domain-name>
console(config)#sntp server 192.168.10.25 ?
key
poll
priority
<cr>
console(config)#sntp server 192.168.10.25
Example #3: Viewing SNTP Information
console#show sntp ?
configuration
status
console#show sntp configuration
Polling interval: 512 seconds
MD5 Authentication keys:
Authentication is not required for synchronization.
Trusted keys:
No trusted keys.
Unicast clients: Disable
18
System Configuration
Require authentication for received Network Time
Protocol (NTP) traffic from servers.
Define an authentication key for Simple Network Time
Protocol (SNTP).
Configure SNTP client broadcast parameters.
Configure the SNTP client parameters.
Configure SNTP server parameters.
Authenticate the identity of a system to which
SNTP will synchronize.
Configure SNTP client unicast parameters.
Enter SNTP server address or the domain name.
Authentication key to use when sending packets to
this peer.
Enable/Disable SNTP server polling.
Configure SNTP server priority.
Press enter to execute the command.
Show the configuration of the Simple Network Time
Protocol (SNTP).
To show the status of the Simple Network Time
Protocol (SNTP).